How to Fix Low Water Pressure in Toilet

How toilets are designed has not actually changed much over the years, where most units being used today contain a water storage tank at the back that holds water above a flapper. When you flush it, the flapper raises to release water into the bowl and then down the drain pipe. Now, if you are experiencing low water pressure in your toilet, it can be caused by many things, including clogged holes around the rim, insufficient water supply and low water level in the tank. To help you with such a problem and increase the flushing power of your toilet, here are some quick fixes that you can perform:

1. Check If The Rim Is Clogged And Fix It.

Water flows to the toilet bowl from the tank through a set of small holes that are located on the underside of the rim. If they are clogged by certain substances, such as lime, the water cannot flow into the bowl at a force that it should normally does. You can use a small mirror to get a good view of the underside rim and check for signs of clogging. Using a nylon brush, clear the holes of any blockage and increase the toilet’s overall flushing pressure.

2. Make Sure That The Water Valve Is Completely Opened.

Most toilets are fed water through a small water valve that is positioned on the floor or wall near the back of the unit. Now, a partially closed valve can affect the fill performance of the toilet tank. Find this valve and make sure that it is completely “on” by turning it counterclockwise with your hand until it stops for the best flushing performance. For some toilet models, they would only require a quarter turn to be fully open.

3. Adjust The Water Level Inside The Tank.

To be able to flush properly, the water level in the tank must be at the right level. Remove the tank lid and try to see if the water level in your toilet tank sits about an inch below the overflow tube. If the water level is lower, you can adjust the float to increase it. If your unit has a ball float, you can turn the screw on top of its fill valve clockwise to get the job done. If your unit uses a cylinder float valve attached to its fill valve, then you can squeeze the clip on the side of the float and pull up the float until you reach the desired water level inside the tank.

Ignoring to fix a slow-flushing toilet can result to clogs along the drain system, which can be very bothersome—it can create a mess that comes with dirty water. Also, it can cause the toilet to be flushed multiple times in a single use, which means water wastage. So, you should fix such a problem as soon as possible. After all, it can be as easy as following the steps provided above.

Categories