Delta Kitchen Faucet Leaking and What to Do

Delta kitchen faucet leaking is very common. You can call in the plumber or you can fix it yourself. The latter will take some time and need some effort but you will save money. Do not ignore any level of Delta kitchen faucet leaking as even a slight leak can lead to wastage of more than three gallons in a day. Not only is that sheer wastage of perfectly clean water, it also leads to an unnecessary spike in your water bill.

Most Delta kitchen faucet leaking is caused by damaged springs and seats. To fix the problem, you will need needle nose pliers, a 1/8 inch wrench, tongue and groove pliers, screwdriver and new parts to replace the old ones. Here are the steps to fix Delta kitchen faucet leaking.

Step 1: Turn Off the Water Supply

The valves would be under the sink. Turn the faucet on and allow the water to drain out of the pipe. Remove the screw cover on the handle, use a wrench or screwdriver to unscrew the cover. Lift the handle and you would find the adjusting ring with the cap. You would be able to check the adjusting ring and gauge if it is tight enough. If not, then the leak could be caused by a loosened adjusting ring. Use the needle-nose pliers to tighten the ring and check if the leaking has stopped. If not, then you must check the springs and seats.

Step 2: Remove the Adjusting Ring

You can just unscrew it. Unscrew the cap. The cap is usually dome-shaped and can be removed using tongue and groove pliers. Use a cloth to get a better grip. Unscrew it but make sure you don’t exert too much force. The cap will bend under extreme pressure.

Step 3: Remove the Cam and Packing

You will find the metal stem, which is usually round. There is a ball inside that must be removed. You can replace the old and worn out cam and packing. If the leak is caused by this then the problem will be resolved. Else, you need to remove and replace the seats and springs.

Step 4: Remove Seats and Springs

The seat is the circular part in the valve and spring is what’s underneath the seat. Take the wrench and you can remove the seats and springs. Get a new pair of springs and seats, insert them into the holes and use the wrench to put them firmly in place. Get a new ball assembly, align the pin as well as the valve with the slot of the ball, replace the cam and packing, reinstall the valve cap and adjusting the ring. Reassemble the handle.

Skip to content