Delta Bathroom Faucet Leaking and Tips for Fixing It

There are many issues at home and one of the most common is dripping faucets. This type of problem can be solved by replacing the rubber seat and spring. Delta bathroom faucet leaks can be solved with careful analysis of the situation.

Tools Necessary for Handling Faucet Repairs

One of the basic requirements when handling faucet repairs is the use of certain tools. Such will include a pair of pliers, Allen wrench or screwdriver, new rubber seating and spring, stem grease, and a new stem if necessary.

Stem Needs to be Replaced Whenever Necessary

  • If you noticed that the handle is already stiff when you try to turn on the faucet, then you should decide to replace the stem.
  • Likewise, if you have seen that there are leaks around the handle whenever you open the faucet.
  • Certain leaks won’t stop even after the seat and spring have been replaced.

Steps to Follow when Deciding to Repair the Leaky Faucet

1. Remove the Handle
Even how experienced you are, you simply have to turn off the water supply every time you encounter repairs, particularly when it comes to plumbing issues.

You can remove the handle after, by simply using an Allen key on the side of the handle or just by unscrewing it.

2. Remove the Bonnet Nut
You will have to remove the bonnet nut after removing the handle holding the stem. The seat and spring should be under the stem, so you must have to remove it. Pliers can be used to remove this or you can use a crescent wrench to unscrew it and pull it up.

3. Remove the Stem
The stem can be removed so that you can access the seat and spring. This set should be replaced by removing first the stem with a pair of pliers. Just don’t lose sight of the exact location of the stem as it will be useful when you ought to reinstall a new one later on.

4. Removing the Seat and Spring
After removing the stem, you can look inside the opening of the faucet handle for the location of the stem. You can also see the rubber seat and spring below the opening. You can remove this by simply putting a tiny screwdriver or an Allen key to pull it up.

5. Installing a New Seat and Spring
The rubber seat should be put on top the new spring. Take note of the arrangement as it should be lined up just like the previous installation. Use a screwdriver or Allen wrench.

6. Replacing the Stem
Put the stem back into place, but don’t forget to grease the O-ring from the stem base using stem grease. Gently install the stem by aligning the tabs on the stem of the body slots. Ensure that you have pushed it down to replace the bonnet nut. Reinstall the bonnet nut in place and use a pair of pliers to screw it back in.

7. Checking for Leaks
Check for some leaks before reinstalling the handle. After you determine the absence of leaks, then you can put the handle back on its position. Then, turn the water supply back on.

Skip to content