The hot water system is a system that heats water only when required. The hot water in the system is gotten from a boiler in the utility room, and the boiler is usually heated by either electricity or oil. The hot water pipes on baseboard are commonly made of copper and are distinctively fin-shaped to facilitate rapid dissipation of heat from the surface of the pipe.
Usually, baseboard heaters are attached under a window on the exterior wall to boost natural convection. The thermostat, on the other hand, is located directly on the heater or on the wall. Baseboard heaters work by passive convection where Heat is produced the electric current flow via the heating element.
Baseboard hot water heating systems, are installed on the baseboard or the lowest possible point on the ground to enable even heating of air in space. Baseboard heating can be an efficient and affordable solution, either for the whole house or as a supplement in rooms underserved by the primary heating system.
Baseboard heaters are considered safe, and incidences of catching fire are minimal. Baseboard heaters are very efficient and convert all the energy they use to yield heat. Nevertheless, if the baseboard heater is improperly used, there is a high risk of fire, and so it is important to observe safety regulations when you are using your system. To keep the heaters functional and safe it is important to clean your heaters regularly with a soft brush vacuum attachment to keep them looking fresh and working properly. This is well achieved by first shutting the power off and removing any foreign material in the heater.
Problems That May Arise In a Baseboard Heater
These are minor problems that you may be experienced while using a baseboard water heater. Though neither of these problems results from malfunctions or misuse, they are sometimes certain drawbacks that develop from the heating process like these and have workarounds you can engage. Some of the problems include expansion problems. Expansion problems occur as a result of naturally happening scientific properties of heat and water. This is where heated water occupies a bigger volume, expands and calls for more space, than when it is cool in its original space.
This problem can be solved by reducing the increased pressure by allowing the returning water go through an air container to compresses the air till pressure becomes equalized. Another issue is pump failure, leaks boiler shut down, excess pressure, clogged radiator and noise that sometimes causes gas bubbles.
Each of the above problems can be prevented or easily solved by regular maintenance to the system and making appropriate modifications at the right points. This will ensure your baseboard water heater has a long and active lifetime.
